DIY wedding ring bowl
This romantic ring bowl with lace pattern and a little heart is perfect for a rustic country wedding.
If you want, you can add your initials to the FIMO using a stamp. There is a jute cord to secure the rings to the bowl, to make sure they don‘t get lost on the way to the altar. The bowl looks especially pretty if you add a sprig of gypsophila, pushing it under the cord.
An article by Dörthe
Cut a piece of FIMOair light about 7 cm wide. Store the remaining FIMOair in an airtight container, for example a screw top jar.
Then roll out the FIMOair to a thickness of about 0.8 cm using the acrylic roller.
Place a small wooden heart and a crocheted or lace doily on the FIMO and roll over them with the acrylic roller to create a pattern.
Alternatively you can use stamps to add letters. Remove the heart and the doily.
Place a small china bowl with a diameter of approx. 8-10 cm on the FIMO sheet and cut round it using the blade.
Remove the FIMOair sheet carefully from the surface it is on, place it on the plate and press down gently so that the FIMO takes on the plate’s rounded form.
Create two holes 0.5 cm from the edge using a straw. Leave to air dry for 24 hours.
Finally thread a jute cord through the holds and attach the rings with a bow.
Follow Dörthe on Instagram
What you need
|Noris® 965 Hobby scissors - Blistercard containing scissors with 17 cm blade||965 17 NBK||1|
wooden heart shape or letter stamps, lace doily, straw, small china bowl, jute cord, dark red acrylic paint
No time right now?
Save this article as PDF!